How to read a strength calculation report in 3 minutes
2026-08-17 · 4-min read
You're handed a strength calculation report. It's packed with numbers and tables.
If you're not the one doing the calculation but the one reviewing or ordering, you don't
need to read it end to end. Look at just three places and you can judge, within 3 minutes,
whether this vessel was designed safely.
What a strength report answers is really one question — "Under these conditions, at this
thickness, is it safe?" So there are three things to look at:
what conditions · what thickness · did it pass.
① First — design conditionsWhat was it calculated on?
Start with the conditions table at the front. Design pressure · design temperature ·
material, and corrosion allowance. All you have to check is whether these match
the customer spec and purchase order. If the premise is wrong, the rest of the calculation is
meaningless however correct it is. (e.g. design pressure 0.3 MPa, temperature 150 ℃,
material A240-316L)
② The core — per-part thickness and judgmentWhat thickness, and did it pass?
A vessel has different thickness per part — shell · top/bottom heads · (jacket) · closure.
Each part has a required thickness (the calculated minimum) and a used thickness (as
actually applied), with a judgment at the end. What to look at is that one judgment cell —
all OK means it passes, and even one NOT OK
means that part is too thin. (e.g. shell 5T · heads 3T/8T · jacket 3T … all OK)
③ The reason — what decided that thicknessWhy this thickness?
Each part is driven up by a different condition — whether internal pressure (pushing out)
governed, or external pressure (pressing in · vacuum · jacket pressure) governed. The table
usually marks it "internal-governed / external-governed." This explains "why exactly this
thickness." An externally-governed part is thicker to survive vacuum or jacket pressure, and that
is on the safe side.
Look at those three and you're done. If the conditions match (①), the judgment is all
OK (②), and the thickness has a reason (③) — the vessel was designed safely.
A strength report — these four things, and 3 minutes is enough
3-minute checklist
Do design pressure · temperature · material · corrosion allowance match the order spec?
Is every part's judgment OK? (even one NOT OK → reject)
Is a head not thinner than the shell? (a common check point in external-pressure cases)
Is the governing condition (internal/external-governed) marked and does it make sense?
Do the thicknesses in the drawing and material list match the report?
One more — when the report, drawing and material disagree
However accurate the strength report is, if the drawing's thickness differs from the
report it's useless. Such mismatches arise when a person copies the calculation results into the
drawing and BOM by hand. So the final check is always "do the three documents have the same
thickness?"
A strength report isn't a document to fear. Conditions · thickness ·
judgment — look at those three and even a non-designer can read whether it's safe.
AUTONEST VC's strength report lays out these three on one page.
Design conditions · per-part thickness · judgment — and the drawing and BOM come from the same
calculation, so they don't disagree.Explore AUTONEST VC →Watch: the 3-tonne jacketed tank run →