Vessel heads come in types — 10% torispherical, 2:1 ellipsoidal, and flat cover. The catch is that each type uses a different thickness formula. If you mostly work with the torispherical head and then meet a 2:1 ellipsoidal one, you have to find and plug in the right formula each time — a fiddly, error-prone spot.
At the same pressure and the same diameter, changing the head type changes the result. A torispherical and a 2:1 ellipsoidal head have different shape factors, and with them the required thickness, tangent length (TL), external-pressure judgment, and capacity all change. By hand, you have to swap the formula itself whenever the type changes — and the less familiar the type, the more you end up digging through references again.
Choosing the head type in the input — that's all. The rest is automatic. With the formula for the chosen type, the thickness, tangent length, external pressure, capacity, drawing, and material list all come out at once, consistent with each other. You can also assign different types to the top and bottom (for example, a flat cover on top and a 2:1 ellipsoidal head on the bottom).
Choosing the formula is a repetitive step where people slip. Once the type is set, the rest of the calculation follows it, so you never have to wonder "which head formula did I use?" — and the result stays consistent to that type for the reviewer too.
A head type is something you decide, not a formula you look up every time. Removing the fiddly part — that's what automation is for.
The head type is one choice — the top and bottom head type on the [Design conditions] tab. The coefficients and formulas come with it.