People who haven't designed a pressure vessel usually think only of "the pressure
pushing from inside." But what really ties up the person doing the calculation is the pressure
pushing from outside — external pressure. Neither calculation is actually slow on its own —
internal pressure takes seconds, external pressure about 5 minutes for one pass. The problem is
that you have to repeat it for every part.
Internal pressure (pushing out)Required thickness = pressure · diameter / (an allowable-stress expression). Put the
values into one formula and the thickness comes right out. Fast, nothing to trip on.
External pressure (pressing in)Not a formula but a back-and-forth on charts (A value → B value). Assume a thickness
→ read from the chart → check if it holds → if not, raise the thickness and repeat. And this
repeats for every part.
One pass is 5 minutes — it's repeating it across every part that adds up
Why external pressure comes "from outside" — vacuum and jacket
A tank is pressed from outside even sitting still. Two typical cases:
Vacuum — draw out the contents or condense steam and the inside goes to vacuum. Then
atmospheric pressure crushes the vessel from the outside. Buckling is the concern, so it
needs a calculation completely different from internal pressure.
Jacket pressure — in a double-jacketed tank, steam or hot water circulating in the
jacket presses the inner shell from outside. From the inner shell's point of view, that
too is external pressure.
Internal pressure is making it "not burst," external pressure is making it "not
buckle." Different physics, so separate calculations — and done by going back and forth over
charts by hand.
That's why hand calculation is slow, and errors creep in
The real cost of the external-pressure calculation is not "once" but "repetition."
Assume a thickness, get the A value and mark it on the chart, read the B value
from the temperature curve, and judge whether it holds — several times for one part (the shell)
alone.
Even if the shell passes, the heads, jacket and closure each go again. Back and forth
over the charts for every part.
Change one thickness and it's back to the start. Reading the graph by eye, values even
differ slightly from one person to the next.
Five minutes for one part means the shell, top head, bottom head, jacket and closure alone add up
fast. Get one thickness wrong and you're back through the loop, adding more. That's how "internal
pressure was instant but external pressure ate hours" happens — five minutes at a time, just many
times over. And reading by eye in a rush is where the accident of reading it on the unsafe
side comes from.
Done automatically — the repetition disappears
This pressure vessel strength calculation follows fixed rules. Rules being fixed means the machine
can do the repetition instead of a person going back and forth over the graph.
Enter vacuum and jacket pressure as conditions and external pressure is judged
automatically, per part.
It even shows which of internal or external pressure governed the thickness — so why
it's this thickness is explained.
Change the thickness and it recomputes at once. The very cost called "repetition"
disappears.
External pressure taking long isn't a matter of skill — it's the structure of
repeating it for every part. Automate that repetition and the five minutes that used to stack up
per part end in a single pass, and mis-reading by eye is gone.
AUTONEST VC judges internal and external pressure together — vacuum and jacket pressure too, per
part.
Even which condition governed, all on one page — no going back and forth over the graph.
Explore AUTONEST VC →Watch: the 3-tonne jacketed tank run →